Aquaseal Flexatile #1 EPDM Roof Flashing – 5-40mm (Terracotta Base)

No, silicone sealant should not be used where the Pipe Flashing seals around the pipe.  This can cause water leaks as the silicone can crack over time and allow water ingress. If the pipe has a seam, then a small amount of sealant can be used along the seam up to the lip of the Pipe Flashing.  Click on the following link for further details – Aquadapt Installation Overview.pdf

Yes, provided a twin or triple skin flue has been installed. Aquarius Rubber recommends their Silicone polymer Pipe Flashings for high temperature applications. Under no circumstances should any polymer pipe flashing be used on single skin flue discharging from a wood heater.

Yes. Aquarius Rubber has developed two sizes designed to suit square pipes from 25mm to 150mm.  (Aquaseal Square Flasher & Versatile Square Flasher)

We recommend a sharp pair of scissors to cut our pipe flashing for the correct pipe size.  Ensure there are no accidental nicks in the polymer, as this will continue to split/tear over time.

Tip: Ensure the blades are sharp with no contamination e.g. glue or any accumulated dirt.

The Aqua Tile, Versatile Aluminium, Flexatile & Versatile LDX are all suitable for drinking water catchments. We do not recommend using a flashing that has a lead base.

Yes, after installation.  We recommend using 100% acrylic paint.

Aquarius Aquaseal’s have measurements on their flashings to help guide the installer for the correct pipe O.D.

If measurements are not available, use the rule of subtracting 18% off the outside diameter of the pipe.  Example, if the pipe is 100mm in OD, subtract 18% of 100mm, this will provide the recommended pipe flashing I.D. of 82mm for a 100mm OD pipe.  This will provide a good interference fit between the pipe flashing and pipe.

Yes. Aquarius polymers are formulated to be Ozone and UV resistant.

Many trades people still use the silicone flashing for heater flues.
When the flue type is a twin or triple skin, tests have shown that the Aquarius black EPDM pipe flashing will adequately do the job and should not be affected by the passive flue heat.

Aquarius Rubber provides a 25 year warranty against defects in material on all pipe flashings. We recommed a licenced plumber for all Aquaseal installations. Aquarius Aquaseal Pipe Flashings have been manufactured in Australia for over 40 years and to this day we can find installations of our original products that are are still performing as expected.

EPDM can withstand temperatures between -40 C° to +115 C°.
Silicone can withstand temperatures between -60 C° to +200 C°